Assemble the Netgate 1100 Shelf
For this page you will need
Tools
Mechanical Components
Networking Compontents
3D printed parts
Step 1: Prepare the tray
- Take the Netgate Shelf you printed earlier and a 2.5mm Allen key.
- Lightly screw a M3x12mm cap screw into the top hole of each of the two rear posts.
- Make sure each screw is inserted less than half way.
Step 2: Secure the Netgate 1100
- Position the Netgate 1100 Firewall Appliance on the shelf so that the ports are visible through the front of the tray
- Tighten each screw until the switch is held firmly
- Do not over tighten the screws in this step as this may damage the plastic.
